Avaya S8700 - Page 1535

EXP-INTF (Expansion Interface Circuit Pack)
Issue 1 May 2002
8-813555-233-143
1141 ABORT The Packet Interface circuit pack is out of service.
1. See ‘‘PKT-INT (Packet Interface)’’ for the recommended repair procedure.
1144 ABORT The PN’s packet bus has a major alarm against it. This test needs to use the
alarmed PN’s packet bus.
1. Enter display alarms and resolve any PKT-BUS alarms.
2. Retry the command.
1394 ABORT The EI circuit pack is out of service and the test cannot be run. This condition is
due to a change in the EI circuit pack’s ability to communicate with the EI or SNI
circuit pack on the other end of the fiber.
1. Run Test #237 and check the Error Log for EXP-INTF Error Type 1281. If
Error Type 1281 is present or if Test #237 does not pass, see the repair
procedures for Test #237, in Table 8-303 on page 8-787.
2. If Test #237 passes, rest the EI pack. Note that this will not be destructive to
the port network where EI circuit pack resides because it will not be serving
as the expansion Archangel if it is not in service.
3. Repeat this test.
1395 ABORT This test cannot be run on an EI circuit pack if it is part of the B-side Port
Network Connectivity and duplicated Port Network Connectivity is not enabled.
1. If this test needs to run on this EI circuit pack, enable Port Network
Connectivity with the change system-parameters duplication command.
2. Prevent the system from doing a PNC interchange by executing the set
PNC lock command.
3. Repeat this test.
Table 8-310. Test #589 Expansion Interface Packet Interface Test — Continued
Error
Code
Test
Result Description / Recommendation
Continued on next page