Avaya S8700 - Page 1608

Maintenance-Object Repair Procedures
555-233-143
8-886 Issue 1 May 2002
1003 ABORT The system could not allocate a Tone-Clock for the test connection. This may
be caused by a heavy load on the system or by a faulted Tone-Clock.
1. Check to see if there are any alarms against the Tone-Clock in the port
network where the test aborted. If so see the recommended procedures
for ‘‘TONE-BD (Tone-Clock Circuit)’’ or ‘‘TONE-PT (Tone Generator)’’.
2. If a new Tone-Clock has been inserted, allow about 1 minute for
maintenance to run on the newly inserted circuit pack.
3. Retry the command at 1-minute intervals up to 5 times.
2000 ABORT Response to the test request was not received within the allowable time period.
1. Retry the command at 1-minute intervals up to 5 times.
2006 ABORT The active Tone-Clock circuit pack or a Tone Detector circuit pack may not be
functioning properly.
1. Test the active Tone-Clock circuit pack in the port network with the test
tone-clock UUC command and see ‘‘TONE-BD (Tone-Clock Circuit)’’ for
failures.
2. Retry the command at 1-minute intervals up to 5 times.
2100 ABORT Could not allocate the necessary system resources to run this test.
Retry the command at 1-minute intervals up to 5 times.
101–
122
FAIL 1. Run the short test sequence: test port UUCSSpp sh r 1.
2. If the problem persists, the system is still operating properly but system
capacity will be reduced. In order to restore the system performance to
normal, replace the tone detector circuit pack containing the defective
GPTD port.
1022 FAIL Tone detection for the system is administered as part of a wideband
configuration, and the tone detector is not a TN420C (the only circuit pack with
this capability). GPTD ports on other types of tone detector circuit packs are
taken out of service since they cannot provide the administered function.
1. Change the tone-detection mode administered on the system-parameters
country-options form, or remove every circuit pack except TN420C tone
detectors from the system.
PASS Tone Detection Verification is successful. The GPTD port is able to detect
every call-progress tone and perform level measurements of test tones.
Table 8-337. Test #42 Tone Detection Verification Test — Continued
Error
Code
Tes t
Result Description / Recommendation
Continued on next page