Maintenance-Object Repair Procedures
555-233-143
8-944 Issue 1 May 2002
Short IP 2-Way Transmission Test (#1505)
This test is a non-destructive test.
Short IP 2-way transmission test is run for the periodic, scheduled, analysis and
short demand tests.
This test attempts to verify IP network connectivity between one pair of IP Media
processors that are connected to the customers LAN/WAN IP network.
This test creates a G.711 audio path between the source IP Media processor
board specified in the command line and a destination IP Media processor board.
The destination media processor board is chosen by the system. The destination
media processor is chosen from a port network other than the port network
containing the source media processor. In addition, the destination media
processor board is chosen from the same IP network region as the source media
processor board or is chosen from an IP network region that is administered to be
connected to the IP network region of the source media processor board.
An audio channel using G.711 is setup between both boards. A 1004-Hz test tone
is transmitted from the source PN to the destination PN over the G.711 audio
channel. The test tone is then transmitted from the destination PN to the source
PN.
To Next Page
Loading...
