Avaya S8700 - Page 1685

IP-SVR (IP Server Interface)
Issue 1 May 2002
8-963555-233-143
Push-Button Switch
The push-button switch is used to administer the switch ID and the cabinet
number of the IPSI. This button can also be used to erase the manually
programmed IP address. Inserting the IPSI board with the button pressed or just
resetting it while the button is pressed will keep the IPSI in boot mode.
Table 8-378. IPSI LEDs
Function LED State Description
TN2312AP
circuit pack
status
Red On/Off TN2312AP circuit pack alarm (controlled by
both the PKT-INT and the Tone-Clock Angel;
logically or-ed together)
Green On/Off TN2312AP test in progress (controlled by
both the PKT-INT and the Tone-Clock Angel;
logically or-ed together)
Amber Off Archangel inactive
Flashing
2 sec on
0.2 sec off
Archangel active
Clock status
(same as
TN2182B)
Amber Flashing
2.7 sec on
0.3 sec off
Active: Master clock, using offboard
synchronization source.
Winking
0.3 sec on
2.7 sec off
Active: Master clock, using its local reference
source.
Steady on Active: Board has been reset and is providing
clocks but has not been told which
synchronization source to use.
Steady off Standby: Applying no tones to the network.
“Jingle Bells”
Green and Amber
0.1 sec on, 0.2 sec off,
0.1 sec on, 0.4 sec off,
0.4 sec on, 0.4 sec off
Standby: Tone generator is being used.
Double blink
Amber
0.3 sec on, 0.3 sec off,
0.3 sec on, 2.4 sec off
Active: Lost all external references and is in
holdover mode.
Random Standby: This LED may come on and off
intermittently as ETR-PTs on the board are
used for tone-detection services.