Avaya S8700 - Page 1730

Maintenance-Object Repair Procedures
555-233-143
8-1008 Issue 1 May 2002
8 ABORT There is a problem with the DS1 interface circuit pack.
1. Consult the procedures for the appropriate DS1 interface circuit pack
(DS1-BD or UDS1-BD).
1004 ABORT B channel in use.
1. Issue the status trunk group#/member# command to determine whether
a call is active on this DS1 ISDN trunk.
2. When the service state indicates in service/idle, retry the test.
1005 ABORT Bad Configuration (such as no Maintenance/Test circuit pack)
1. Make sure the Maintenance/Test circuit pack is inserted.
2. Repeat the test.
1018 ABORT Test call is disabled.
1. Enable Maintenance on the Trunk Group form.
1019 ABORT Another Test call is in progress.
1. Issue the list isdn-testcall command to locate the test call.
2. Issue the status isdn-testcall command to find out the duration and start
time of the test call.
3. Issue the clear isdn-testcall command to stop the test call from running.
4. If time and duration indicate that the test call should have stopped, and the
clear isdn-testcall command does not work, see‘‘M/T-DIG
(Maintenance/Test Digital Port)’’ for recommended maintenance strategy.
1020 ABORT There is a problem with the DS1 Interface circuit pack.
1. See ‘‘DS1-BD (DS1 Interface Circuit Pack)’’ or ‘‘UDS1-BD (UDS1 Interface
Circuit Pack)’’.
1024 ABORT (M/T-DIG) Maintenance/Test Digital Port in use.
1. Wait until yellow and green LEDs are turned off on the M/T-BD
(Maintenance/Test circuit pack).
2. Retry test. If problem persists, see‘‘M/T-DIG (Maintenance/Test Digital
Port)’’.
1113 ABORT The signaling link has failed. Therefore, the system cannot send any
messages on behalf of this trunk.
1. Check the results of the Signaling Link State Check test (#255).
Table 8-400. Test #258 ISDN Test Call — Continued
Error
Code
Tes t
Result Description / Recommendation
Continued on next page