Maintenance-Object Repair Procedures
555-233-143
8-1078 Issue 1 May 2002
NT Reset Test (#1381)
This test is destructive.
This test resets the circuit pack. The test is highly destructive and can only be
initiated by a system technician-demanded reset board UUCSS command.
2801 ABORT No IP address defined. Verify IP Interfaces translations and retest.
2802 ABORT Different IP address pinged than software had allocated for the test.
1. Retry the command at 1-minute intervals up to 3 times.
2805 FAIL The number of pings received did not match the number sent (normally one
ping sent). This means that no ping responses were received from the
gateway defined on the ip-interfaces form for the Media Processor.
1. Retry the command at 1-minute intervals up to 3 times.
2807 ABORT The board is administered, but not enabled in the change ip-interfaces form.
7, 89,
1007
FAIL Ping to the destination failed through this port due to the destination down.
1. Verify that at least one destination reachable through this port is up.
2. Once verified, execute test port UUCSSpp command to verify that the
H.323 Signaling Group Ping test (#1387) passes.
PASS Ping through this port successful.
Table 8-440. Test #1381 NT Reset Test
Error
Code
Tes t
Result Description / Recommendation
None ABORT System resources required for this test are not available.
1. Retry the reset board UUCSS command at 1-minute intervals up to 5
times.
1015 ABORT Port is not out-of-service.
1. Busyout the circuit pack (busyout board UUCSS).
2. Execute the reset board UUCSS command again.
Continued on next page
Table 8-439. Test #1379 Ping Test — Continued
Error
Code
Tes t
Result Description / Recommendation
Continued on next page
To Next Page
Loading...
