MODEM-PT (Modem Pool Port)
Issue 1 May 2002
8-1137555-233-143
Error Log Entries and Test to Clear Values
System Technician-Demanded Tests:
Descriptions and Error Codes
Always investigate tests in the order presented in the table below when inspecting
errors in the system. For example, by clearing error codes associated with the
Modem Pool Conference test (#97), you may also clear errors generated from
other tests in the testing sequence.
NOTE:
The tests in this section do not apply to Combined Modem Pool conversion
resources. The standard Digital Line and/or Analog Line port tests are run
on the ports associated with the Combined Modem Pool. Consult the test
descriptions for those MOs when repairing Combined Modem Pool
arrangements.
Table 8-466. Modem Pool Port Error Log Entries
Error
Type
Aux
Data Associated Test
Alarm
Level
On/Off
Board Test to Clear Value
0
1
1. Run the short test sequence first. If every test passes, run the long test sequence. Refer to each appropriate
test’s description, and follow its recommended procedures.
0Any Any Anytest port UUCSSpp sh r 1
18 0 busyout UUCSS WARNING OFF release port UUCSS
130
2
2. This error type indicates that the circuit pack has been removed or has been insane for more than 21 minutes.
To clear the error, reinsert or replace the circuit pack.
None WARNING ON test port UUCSSpp sh
257 Conversion Resource Loop
(#98)
MINOR ON test port UUCSS s r 3
513 Modem Conference (#97) MINOR ON test port UUCSS l r 3
769 Modem NPE Crosstalk (#96) MINOR ON test port UUCSS l r 3
Order of Investigation
Short Test
Sequence
Long Test
Sequence D/ND
1
1. D = Destructive, ND = Nondestructive
Modem Pool NPE Crosstalk test (#96) X D
Modem Pool Conference test (#97) X D
Modem Pool Conversion Resource
Loop-around test (#98)
XXND
Modem Pool Audits test (#99) X X ND
To Next Page
Loading...
