Avaya S8700 - Page 1890

Maintenance-Object Repair Procedures
555-233-143
8-1168 Issue 1 May 2002
1003 ABORT The system could not allocate a tone receiver for the test. The system may be
oversized for the number of tone detectors present, or some tone detectors
may be out-of-service.
1. Resolve any TTR-LEV errors.
2. Resolve any TONE-PT errors.
3. If neither condition exists, retry the command at 1-minute intervals up to 5
times.
4. If the test continues to abort, escalate the problem.
1004 ABORT The port was seized by a valid ISDN-PRI test call. Use the list isdn-testcall
command to determine which call is using the port (from the M/T Port column).
Either wait for the test call to complete (as indicated in the
Start Time and
Duration fields of the above display), or abort the test call with the clear
isdn-testcall grp/mem command, where grp/mem is determined from the
B-channel field of the above display.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to abort and the port is idle, escalate the problem.
2000 ABORT Response to the test request was not received within the allowable time period.
2100 ABORT System resources required to run this test are not available.
1. Retry the test at 1-minute intervals up to 5 times.
2. If the test continues to abort, escalate the problem.
7 FAIL Conference test failed on the primary information channel. In most cases, the
user may not notice a disruption in service.
1. Run the circuit pack tests to check the Tone Generator circuit pack and the
Tone Detector circuit pack via the test board UUCSS command.
2. Resolve any problems that are detected on the Tone Generator circuit pack
or Tone Detector circuit pack.
3. If the Tone Generator and Tone Detector circuit packs are functioning
properly, and the test still fails, replace the Maintenance/Test circuit pack.
Table 8-478. Test #13 Digital Port Loop-Around Test — Continued
Error
Code
Tes t
Result Description / Recommendation
Continued on next page