Avaya S8700 - Page 2042

Maintenance-Object Repair Procedures
555-233-143
8-1320 Issue 1 May 2002
Table 8-530. Test #1275 SCOTCH Synchronous Loop-Around Test
Error
Code
Tes t
Result Description / Recommendation
1000 ABORT The port is in use or PPP link is connected.
1. Determine when the port is available for testing (status clan-port
UUCSSpp).
2. The port may be forced to the idle state by executing a busyout port
UUCSSpp command.
NOTE:
This command is destructive, causing every call and link using the port
to be torn down.
1002 ABORT No TDM bus timeslots available for the test.
1. Retry the command at 1-minute intervals up to 5 times.
2. Escalate if the problem persists.
1963 ABORT Firmware indicates that the port is in use or ppp link is connected.
1. Determine when the port is available for testing (status clan-port
UUCSSpp).
2. The port may be forced to the idle state by executing a busyout port
UUCSSpp command.
NOTE:
This command is destructive, causing every call and link using the port
to be torn down.
2000 ABORT Did not receive circuit pack test response within the allowable time period.
1. If this problem persists, reset the circuit pack (busyout board UUCSS,
reset board UUCSS, and release board UUCSS).
2. If the problem persists, replace the circuit pack.
2012 ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 3 times.
2. Escalate if the problem persists.
2100 ABORT Could not allocate the necessary system resources to run test.
1. Retry the command at 1-minute intervals up to 5 times.
2. Escalate if the problem persists.
FAIL C-LAN circuit pack detected test failure.
1. If the problem persists, reset the circuit pack (busyout board UUCSS,
reset board UUCSS, and release board UUCSS).
2. If the problem persists, replace the circuit pack.
PASS Port circuitry functioning properly.
Continued on next page