Maintenance-Object Repair Procedures
555-233-143
8-1322 Issue 1 May 2002
Session Status Test (#1286)
This nondestructive test determines the status of every PPP port session. This
test queries the system software on port session status.
2100 ABORT Could not allocate the necessary system resources to run test.
1. Retry the command at 1-minute intervals up to 5 times.
2. Escalate if the problem persists.
2500 ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 3 times.
2. Escalate if the problem persists.
1003 FAIL Ping to the destination failed due to on-board problem.
1. Retry the command at 1-minute intervals up to 3 times.
2. If the problem persists, reset the circuit pack (busyout board UUCSS,
reset board UUCSS, and release board UUCSS).
3. If the problem persists, re-administer the PPP connection through a
different PPP port, if available.
4. If the problem still persists, or if there are no other available PPP ports,
replace the circuit pack.
1007 FAIL Ping to the destination failed due to the destination down.
1. A PPP destination or a component in the path (e.g., DS1 trunk) may be
down. Check the status of the destination or other components in the path.
2. If the destination and every component in the path is in-service, ping the
PPP destinations (ping ip-address xxx.xxx.xxx.xxx).
3. Escalate if the problem persists.
PASS TCP/IP Ping test (#1281) is successful.
If the system software indicates that: Then the switch:
Every port session is up (ALL UP) Raises no alarm, or retires alarm
Some port sessions are up (SOME UP) Raises MINOR alarm
Every port sessions is down (ALL DOWN) Raises MINOR alarm
Table 8-531. Test #1281 TCP/IP Ping Test — Continued
Error
Code
Tes t
Result Description / Recommendation
Continued on next page
To Next Page
Loading...
