Additional Maintenance Procedures
555-233-143
5-20 Issue 1 May 2002
To place the call:
1. Dial the FAC described above and listen for dial tone.
2. Dial the port network number followed by **** and listen for one of the
following tones:
3. Repeated test calls will alternate between out-of-service time slots on TDM
bus A and TDM bus B.
System Tone Test Call
This test connects the voice terminal to a specific system tone.
To place the call:
1. Dial the FAC described above.
2. Dial the port network number followed by * and the two-digit tone
identification number from the following table.
3. Listen for one of the following tones:
NOTE:
For a definition of call progress tones see Overview for Avaya
MultiVantage™ Software.
Reorder tone There are no out-of-service time slots on the
specified port network.
Confirmation tone Connection is made to an out-of-service time slot.
Intercept tone The number entered is not a valid tone number.
Reorder tone Inter-PN resources are not available.
System tone The specified tone will be heard if it is functioning.
Table 5-3. System Tone Identification Numbers
Number Description
00 Null tone
01 Dial tone
02 Reorder tone
03 Alert tone
04 Busy tone
05 Recall dial tone
Continued on next page
To Next Page
Loading...
