SN-CONF (Switch Node Configuration)
Issue 1 May 2002
8-1379555-233-143
h. The SNI is administered to be connected to a DS1C but is not.
To resolve this error, refer to FAIL code 139 for test 759.
i. The SNI is connected to a DS1C, but no DS1C is administered.
To resolve this error, refer to FAIL code 140 for test 759.
System Technician-Demanded Tests:
Descriptions and Error Codes
Always investigate tests in the order presented in the table below when inspecting
errors in the system. For example, by clearing error codes associated with the
Configuration audit (#759), you may also clear errors generated from other tests
in the testing sequence.
Configuration Audit (#759)
This test is nondestructive.
NOTE:
For descriptions of result codes for this test see:
■ ‘‘SNC-BD (Switch Node Clock Circuit Pack)’’ when the circuit pack tested is
a Switch Node Clock (circuit pack slots 10 or 12).
■ ‘‘SNI-BD (SNI Circuit Pack)’’ when the circuit pack tested is a Switch Node
Interface (circuit pack slots 2–9 or 13–20).
This test is run via the test board short or test board long command for SNI
circuit packs or SNC circuit packs.
For SNI circuit packs, this test queries the SNI for SNCs in the same switch node
carrier, SNI peers, DS1Cs, and EI or SNI neighbors that the SNI can
communicate with and compares this data to the administered data.
For SNC circuit packs, this test queries the SNC for SNCs and SNIs in the same
switch node carrier that the SNC can communicate with and compares this data to
the administered data.
Failures of this test cause entries in the error and alarm logs against Switch Node
Configuration (SN-CONF) with the board location of the SNI or SNC.
Order of Investigation
Short Test
Sequence
Long Test
Sequence
Reset Board
Sequence D/ND
1
1. D = Destructive, ND = Nondestructive
Configuration audit (#759) X X ND
Processor Route audit (#760) X ND
To Next Page
Loading...
