Maintenance-Object Repair Procedures
555-233-143
8-1532 Issue 1 May 2002
Test Synchronization Test (#417)
This test updates every Synchronization Maintenance component with the correct
information about its role in providing a system’s synchronization. Specifically,
this test updates every:
■ IPSI circuit pack’s Tone-Clock circuit
■ Tone-Clock, Expansion Interface, DS1 Interface, and UDS1 Interface
circuit pack
in the system. The test either passes or aborts.
Table 8-594. Test #n (Name of) Test
Error
Code
Test
Result Description / Recommendation
1000 ABORT System resources required to run this test are not available.
1. Retry the command at 1-minute intervals up to 3 times.
1115 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 3 times.
2500 ABORT Internal system error
1. Retry the command at 1-minute intervals up to 3 times.
PASS The Synchronization Maintenance component circuit-pack parameters have
been successfully updated. The system should be synchronized after
successful execution of this test. If synchronization problems still exist, refer to
the Error Log to obtain information about the source of the problem.
Continued on next page