Avaya S8700 - Page 2278

Maintenance-Object Repair Procedures
555-233-143
8-1556 Issue 1 May 2002
Table 8-603. Test #595 LAN Receive Parity Error Counter Test
Error
Code
Tes t
Result Description / Recommendation
2000 ABORT Response to the test was not received from the circuit pack within the allowable
time period.
1. If the test aborts repeatedly up to 5 times, reset the circuit pack via the
busyout board UUCSS and reset board UUCSS commands.
2. If the test aborts again, replace the circuit pack.
2100 ABORT Could not allocate the necessary system resources to run this test.
2012 ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
1–10 FAIL The circuit pack is still detecting errors of this type. The error code indicates
the value of the on-board error counter.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to fail, verify the validity of the Packet bus. Run the
Packet bus maintenance test with the test pkt P long command. If any
Packet bus tests fail, see ‘‘PKT-BUS (Packet Bus)’’ on page 8-1230 for
recommended repair procedures.
3. If the Packet bus test passes, check the validity of the circuit pack.
Execute a test that involves data transmission onto the Packet bus. For
example, the test port UUCSSpp command may use the connectivity
tests of the BRI-PORT MO. If the test fails, refer to the repair procedures;
otherwise, proceed to the next step.
4. Other circuit packs on the Packet bus may be causing of the parity error.
Use the display errors command to check the Error Log for alarmed other
circuit packs. Resolve any alarms for other circuit packs as well. Rerun
the LAN Receive Parity Error Counter test (#595).
PASS No errors detected.
Continued on next page