Avaya S8700 - Page 2289

TBRI-PT (ISDN Trunk-Side BRI Port)
Issue 1 May 2002
8-1567555-233-143
Table 8-608. Test #618 BRI Port Local LAN Loop Around
Error
Code
Tes t
Result Description / Recommendation
1015 ABORT The port is not out-of-service.
1. Use the status bri-port UUCSSpp command to determine the status of
the port.
2. If it is in use, wait until it is idle, and then use the busyout port UUCSSpp
command to place it in the out-of-service state and repeat this test.
!
CAUTION:
Since the busyout command is destructive, execution of this
command prior to the port being idle causes every call associated
with the BRI port to be torn down.
1139 ABORT The Packet bus in the port network is out-of-service.
1. Follow the repair procedures for the Packet bus.
2. Run the test port long UUCSSpp command and verify the repair by
viewing the results of the BRI Port Local LAN Loop-Around test (#618).
1141 ABORT The PKT-CTRL is out-of-service.
1. Follow the repair procedures for the PKT-CTRL.
2. Run the test port long UUCSSpp command and verify the repair by
viewing the results of the BRI Port Local LAN Loop-Around test (#618).
2012
2100
ABORT Internal system error
Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
FAIL The Loop-Around test has failed.
1. If the test fails repeatedly, attempt to reset the circuit pack with the
busyout board UUCSS and the reset board UUCSS commands if the
other ports on the board are idle.
2. If the test fails again, execute test pkt P. If this fails, follow failure
procedures in the PKT-BUS section.
3. If the tests in Step 2 pass, the problem is local to the BRI board. Replace
the trunk circuit pack.
PASS The BRI Port Local LAN Loop-Around test passed.
Continued on next page