Maintenance-Object Repair Procedures
555-233-143
8-1574 Issue 1 May 2002
Layer 3 Query Test (#1243)
This test is nondestructive.
This test is used to check the application layer communications across the
in-service ISDN D channel. The test passes if a status enquiry message is
successfully sent, fails if the signaling link is down, and aborts if a query is already
running or there is an internal error.
4 FAIL Received a status of Level 1 Pending Activation, the NT1 has a loss of power
indicating a problem with the NT1.
1. Follow the manufacturer-recommended repair procedures for the NT1.
2. Execute the test port UUCSSpp command and review the results of the
Level 1 Status Inquiry test to verify the repair.
PASS This test indicates that Level 1 is activated or that software has taken the port
out of service.
Table 8-613. Test #1243 Layer 3 Query
Error
Code
Tes t
Result Description / Recommendation
1005 ABORT The test aborted due to a configuration problem. This test may not be
applicable, or it may be disruptive to terminal equipment other than a voice
terminal (for example, a modem pool member or Music on Hold). This error
can be ignored.
1019 ABORT Test is already running.
1113 ABORT The signaling link is down.
1. Use the test port UUCSSpp long command to clear any errors which
prevent establishment of the signaling link.
2. Examine the results of Test #626, which is executed with the command. If
this test aborts or fails, follow the repair procedure for the Signaling Link
Status test.
3. Escalate problem if BRI Layer 3 Query test continues to abort.
Continued on next page
Table 8-612. Test #1242 Level 1 Status Inquiry — Continued
Error
Code
Tes t
Result Description / Recommendation
Continued on next page
To Next Page
Loading...
