Avaya S8700 - Page 2325

TDM-BUS (TDM Bus)
Issue 1 May 2002
8-1603555-233-143
Digit Detection Test (#297)
This test is executed on the Non-Control Channel bus. The Tone-Clock circuit is
told to put a tone on the Non-Control Channel bus and the Tone Detector circuit is
told to listen to it. The test passes if the tone is successfully transmitted on the
Non-Control Channel bus.
Table 8-622. Test #297 Digit Detection Test
Error
Code
Tes t
Result Description / Recommendation
None,
1001,
2100
ABORT Could not allocate the necessary system resources to run this test.
1005 ABORT Since this test is valid only on the non-control channel bus, it aborts execution
when run on the control channel bus. This is a valid response. Use the status
port-network command to verify which bus is the control channel bus.
2000 ABORT Response to the test request was not received within the allowable time period.
1. Retry the command at 1-minute intervals up to 3 times.
None FAIL This failure indicates that communication on the Non-Control Channel is not
reliable.
1. Execute the command again.
2. If the problem persists, test the active Tone-Clock circuit and Tone Detector
circuit/circuit pack in the port network where the faulted TDM bus resides,
to make sure they are healthy. See ‘‘TONE-BD (Tone-Clock Circuit)’’,
‘‘TONE-PT (Tone Generator)’’, ‘‘GPTD-PT (General-Purpose Tone
Detector Port)’’, and
‘‘DTMR-PT (Dual-Tone Multifrequency Receiver
Port)’’.
3. Execute the command again.
4. If the problems persists, see ‘‘TDM-Bus Fault Detection and Isolation’’.
PASS The non-control channel bus is operational.
Continued on next page