UDS1-BD (UDS1 Interface Circuit Pack)
Issue 1 May 2002
8-1735555-233-143
SAKI Sanity Test (#53)
This test is destructive.
This test resets the circuit pack. The test is highly destructive and can only be
initiated by a system technician-demanded reset board UUCSS command.
Table 8-671. Test #53 SAKI Sanity Test
Error
Code
Tes t
Result Description / Recommendation
None ABORT System resources required for this test are not available.
1. Retry the reset board command at 1-minute intervals up to 5 times.
1005 ABORT Wrong circuit pack configuration to run this test. This error applies only to DS1
Interface circuit packs. It means the DS1 Interface circuit pack is providing
timing for the system, and therefore, it cannot be reset without major system
disruptions.
1. If the circuit pack needs to be reset, then set synchronization to another
DS1 Interface circuit pack or to the IPSI or Tone-Clock circuit pack and try
again. See ‘‘SYNC (Port-Network Synchronization)’’ on page 8-1509.
1015 ABORT Port is not out-of-service.
1. Busyout the circuit pack.
2. Execute the reset board command again.
2100 ABORT System resources required for this test are not available.
1. Retry the reset board command at 1-minute intervals up to 5 times.
1 FAIL The circuit pack failed to reset.
2 FAIL The circuit pack failed to restart.
1. Execute the reset board command again.
2. If the problem persists, replace the circuit pack.
PASS The circuit pack initializes correctly.
1. Run the short test sequence.
Continued on next page
To Next Page
Loading...
