Avaya S8700 - Page 2554

Maintenance-Object Repair Procedures
555-233-143
8-1832 Issue 1 May 2002
Link Status Test (#601)
This non-destructive test determines the state of the call-control signaling link for
VALs. If the signaling link is physically connected, the test sends a test frame
over the link and checks for a response. The test passes only if both the signaling
link is connected and the test frame is successfully transmitted.
A failure can indicate a problem with:
■ this circuit pack
■ the packet bus
■ the Packet Interface circuit pack
Table 8-700. Test #601 Link Status Test
Error
Code
Tes t
Result Description / Recommendation
1125 ABORT RSCL link or VAL board not in service.
1. Release the board.
2. Repeat the test.
3. Escalate if the problem persists.
2012 ABORT Could not allocate the necessary system resources to run this test.
2100 ABORT Internal system error.
1. Retry command at 1-minute intervals up to 5 times.
2. If the problem persists, escalate the problem.
2 FAIL The RSCL control link disconnected.
1. Retry command at 1-minute intervals up to 5 times.
2. If the test continues to fail, execute the Packet Interface test (#598) (test
board UUCSS) to see if the problem is in the circuit pack.
■ If the Packet Interface test (#598) fails, see ‘‘Packet Interface Test
(#598)’’ repair procedures.
■ If the Packet Interface test (#598) passes, see ‘‘Packet Interface Test
(#598)’’ and Packet bus repair procedures.
3 FAIL Received no response to RSCL control link test frame.
1. Retry command at 1-minute intervals up to 5 times.
2. If the problem persists, reset the circuit pack (reset board UUCSS).
3. If test continues to fail, replace the circuit pack.
PASS RSCL control link connected.
Continued on next page