Maintenance-Object Repair Procedures
555-233-143
8-1838 Issue 1 May 2002
status link Generate a status report about a specific administered Ethernet link.
(For VAL this means the administered Ethernet link.)
status val-ip Generate an IP-related, MIB data status report.
netstat ip-route Generate a report showing the status of the VAL IP routes on the VAL
circuit pack.
list directory board See the file contents of a VAL circuit pack by location.
remove file Delete an announcement or firmware image file on a VAL circuit pack.
enable filesystem Begin an FTP session into a specific TN2501AP circuit pack.
disable filesystem End an FTP session into a specific TN2501AP circuit pack.
set ethernet-options Manually or automatically set the Ethernet connection’s parameters.
get ethernet options Generate a report about a specific Ethernet connection.
set boot-image Direct the system to use 1 of 2 possible firmware image files on the
TN2501AP circuit pack.
get boot-image View the two firmware image parameters on the VAL circuit pack.
Table 8-702. VAL maintenance commands — Continued
Command Use this command to
Continued on next page
To Next Page
Loading...
