Avaya S8700 - Page 2593

WAE-PORT (Wideband Access Endpoint Port)
Issue 1 May 2002
8-1871555-233-143
Port Audit and Update Test (#36)
This test sends port level translation data from switch processor to the UDS1
Interface circuit pack to ensure that the wideband access endpoint port’s
translation is correct.
Table 8-719. Test #36 Audit and Update Test
Error
Code
Tes t
Result Description / Recommendation
ABORT Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
1006 ABORT The port is out-of-service. If the port is busied out:
1. Issue release access-endpoint extension command to put the port back
into in-service.
2. Retry the test command. If the port is not busied out:
a. Check the error and alarm logs for WAE-PORT and UDS1-BD errors
and alarms and follow the recommended repair procedures.
2000 ABORT Response to the test request was not received within the allowable time period.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
FAIL Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
PASS Port translation has been updated successfully.
Continued on next page