Maintenance Commands
555-233-143
7-78 Issue 1 May 2002
Output (Page 2)
The following example shows the output from page 2 of the change
system-parameters maintenance
command.
Field Descriptions (Page 2)
Start
Date/Time
This field only appears if the Schedule Download field is set to y. The
date portion of the field is formatted: mm/dd/yyyy (mm=2 digits for the
month, dd=2 digits for the day and yyyy = 4 digits for the year). The time
portion of the field is formatted: hh:mm (hh=2 digits for the hour and mm =
2 digits for the minutes).
Stop Date/Time
This field only appears if the Schedule Download field is set to “y”.
The date portion of the field is formatted: mm/dd/yyyy (mm=2 digits for the
month, dd=2 digits for the day and yyyy = 4 digits for the year). The time
portion of the field is formatted: hh:mm (hh=2 digits for the hour and mm =
2 digits for the minutes). If this field is left blank, the download will continue
until completion.
Target
Location
These fields contain the target board locations (ppcss) of the boards that
will receive the download file image.
Continued on next page
change system-parameters maintenance Page 2 of 3
MAINTENANCE-RELATED SYSTEM PARAMETERS
MINIMUM MAINTENANCE THRESHOLDS ( Before Notification )
TTRs: 4 CPTRs: 1 Call Classifier Ports: 0
MMIs: 0 VCs: 0
TERMINATING TRUNK TRANSMISSION TEST ( Extension )
Test Type 100: Test Type 102: Test Type 105:
ISDN MAINTENANCE
ISDN-PRI Test Call Extension: ISDN-BRI Service SPID:
DS1 MAINTENANCE
DS0 Loop-Around Test Call Extension:
To Next Page
Loading...
