display alarms
Issue 1 May 2002
7-93555-233-143
Feature Interactions
If the alarm origination is disabled by “change system-parameters maintenance,”
the
Ack? field displays blanks no matter what the true acknowledge state is for
the alarm.
If “second-as-backup” is administered in the
Alarm Origination to OSS
Numbers
field, the column under the “2” heading will be blank for the alarms that
the switch has not attempted to send to the second OSS telephone number. For
the alarms that the switch has attempted to send to the second OSS telephone
number, the column will be “y,” “n,” or “c,” depending on the acknowledgment
status of the alarm. After calling the first OSS telephone number becomes
successful, for the alarms that the switch has attempted to send to OSSN2, the
column will be consistent with the column under the “1” heading.
Service
State
RDY (ready for service), OUT (out of service), or IN (in service). This is the
current service state of the station and trunk ports shown. If a blank is displayed
in this field it means that no service state is associated with the MO.
Ack?
The columns under the “1” and “2” headings denote if the alarm has been
acknowledged by the first and second OSS telephone numbers, respectively. A
“y” in this field means that the alarm has been acknowledged. An “n” means that
the alarm has not been acknowledged. A “c” means that the alarm resolved and
cleared and the alarm notification was acknowledged. A blank means that there
will be no attempt to report the alarm.
Date Alarmed
Day, hour, and minute of alarm.
Date
Resolved
Day, hour, and minute of resolution. For active alarms this field is zero (0).
To Next Page
Loading...
