Maintenance Commands
555-233-143
7-194 Issue 1 May 2002
These measurements are displayed by software; the report output may span
multiple IP Media Processor or Medpro boards. A single report output combines
statistics from both IP Media Processor and Medpro boards. Codecs are
considered as part of a common pool.
Output
The following example shows the IP Codec Hourly Output For Region 4.
Field Descriptions
Meas Hour
The hour the measurement was taken. Switches in multiple time zones are
treated as in the current MMI reports. We do not assume that the customer
has made any correlation between LAN regions and time zones. Range:
0000 – 2300.
Region
The network region that the IP Media Processors and Medpros for this
measurement are in. (The increase to 44 regions is required by [75101-2].)
Range: 1–44.
DSP Rscs
Total IP codec resources (voice channels) in the region. (22 or 31) * #
Medpro + 64 * #IP Media Processors. The 22 or 31 multiplier for Medpro
depends on admin of codec preferences. For R10, a G711 call takes 1
resource, while a G723/729 call or a Fax relay call takes 2 resources.
Range: 0–9999.
list measurements ip codec hourly 4
Switch Name: Date: 5:32 pm WED MAR 26, 2002
IP CODEC RESOURCE HOURLY REPORT
G711 G723/9
--------------------- -------------------------
Meas DSP Usage In Reg Out of Usage In Reg Out of
Hour Region Rscs (Erl) peg Reg peg (Erl) peg Reg peg
0400 4 xxxx xxxx.x xxxxx xxxxx xxxx.x xxxxx xxxxx
0300 4 xxxx xxxx.x xxxxx xxxxx xxxx.x xxxxx xxxxx
0200 4 xxxx xxxx.x xxxxx xxxxx xxxx.x xxxxx xxxxx
0100 4 xxxx xxxx.x xxxxx xxxxx xxxx.x xxxxx xxxxx
0000 4 xxxx xxxx.x xxxxx xxxxx xxxx.x xxxxx xxxxx
2300 4 xxxx xxxx.x xxxxx xxxxx xxxx.x xxxxx xxxxx
2200 4 xxxx xxxx.x xxxxx xxxxx xxxx.x xxxxx xxxxx