reset pnc interchange
Issue 1 May 2002
7-259555-233-143
Output
One of the following messages is displayed:
Command successfully completed
If the reset pnc interchange command is unsuccessful due to the standby PNC’s
state of health (operation of anti-thrashing), the following message will be
displayed:
Interchange of pnc failed;
try again using the ’override-and-lock’ identifier
See the preceding caution regarding use of the override-and-lock option. If the
reset pnc interchange command is unsuccessful due to a busyout of the standby
PNC, the following message will be displayed:
Must release port network connectivity first
To Next Page
Loading...
