set options
Issue 1 May 2002
7-275555-233-143
Error Messages
If the command entered is in conflict with another currently executing command,
then a message is displayed showing the login id of the conflicting user and the
conflicting command. The message is as follows:
’login id’:’command’ has a command conflict
If during the execution of a command a resource problem occurs that requires the
user to restart the command, then the following message is displayed:
Command resources busy;
Press CANCEL to clear, and then resubmit
If every available maintenance resource is currently in use, then the following
message is displayed:
All maintenance resources busy; try again later
Form Input
After entering the command set options, the user is presented with the following
form.
set options Page 1 of 22
ALARM REPORTING OPTIONS
Major Minor
On-board Station Alarms: w w
Off-board Station Alarms: w w
On-board Trunk Alarms (Alarm Group 1): y y
Off-board Trunk Alarms (Alarm Group 1): w w
On-board Trunk Alarms (Alarm Group 2): w w
Off-board Trunk Alarms (Alarm Group 2): w w
On-board Trunk Alarms (Alarm Group 3): w w
Off-board Trunk Alarms (Alarm Group 3): w w
On-board Trunk Alarms (Alarm Group 4): w w
Off-board Trunk Alarms (Alarm Group 4): w w
On-board Adjunct Link Alarms: w w
Off-board Adjunct Link Alarms: w w
Off-board MASI Link Alarms: w
Off-board DS1 Alarms: w w
Off-board TCP/IP Link Alarms: w w
Off-board Alarms (Other): w w
To Next Page
Loading...
