EasyManua.ls Logo

Avaya S8700 - Page 583

Avaya S8700
2618 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
status conference
Issue 1 May 2002
7-327555-233-143
Field Descriptions
Join Time
Time (in 24-hour notation) when the channel joined the conference.
Drop Time
Time (in 24-hour notation) when the channel disconnected. If the first channel
has a drop time, then it means that the endpoint is idle. If there is a drop time
without a join time, it means that the call disconnected without being joined to
the conference.
Drop Reason
The reason for the channels disconnect:
2-pri This drop reason occurs when an administration error causes a
mismatch in primary-secondary designation for a cascade link. This
mismatch shows that both MCUs are administered as primaries (see
Cascading for a description of primary-secondary compatibility).
2-sec This drop reason occurs when an administration error causes a
mismatch in primary-secondary designation for a cascade link. This
mismatch shows that both MCUs are administered as secondaries (see
Cascading for a description of primary-secondary compatibility).
Agent The reservation agent has caused the call to disconnect (for
example, the agent has changed a connected dial-out destination number).
Bandwidth mismatch between a call and the conference it attempted to
join. For example, a 56-kbps call attempted to join a 64-kbps conference
that does not allow rate adaptation.
BondHshake BONDing handshake drop reason can be caused due to
the following reasons: information channel parameter not supported or
invalid, parameter negotiation terminated out of sequence, timer expired
because of the secondary channels did not establish, or BONDing framing
was not detected for one of the other channels.
Busy This dial-out drop reason occurs when the MCU detects that the
conferees terminal equipment is busy. This drop reason is detected by an
ISDN cause value (for example h0). See Dial-out for a description of
CPTR usage.
Chair disconnected the endpoint, using either Chair Command
Disconnect (CCD) or Chair Command Kill (CCK) signals.
Conf End The conference was ended due to reaching stop time for a
reserved conference or due to an active conference being converted to file.

Table of Contents

Other manuals for Avaya S8700

Related product manuals