Maintenance Commands
555-233-143
7-360 Issue 1 May 2002
Link/Port Status Form (Page 1)
Field Descriptions, Page 1
Link Number
Administered link number (assigned by add/change data-module
command)
Link Status
Displays no, yes, unavail, connected, disconnected, enabled,
out-of-service, or restarting
Link Type
The type of interface according to the physical/link protocol(s)
immediately “below” the network layer in the protocol stack
(Ethernet or PPP)
Link Name
Administered link name (assigned by add/change data-module
command)
Service Port Location
Administered port location (assigned by add/change data-module
command)
Service Port Data
Extension
Administered extension number (assigned by add/change
data-module command)
Service State
Displays: in-service/idle, in-service/active, disconnected,
out-of-service, maintenance busy, in-service, inactive, active, idle
Node Name
Administered node name for TCP/IP endpoint (assigned by
add/change data-module command)
Source IP Address
IP address administered for node name (assigned with change
node-name or add/change data-module commands)
Enabled
y (yes) or n (no)
Maintenance Busy?
y (yes) or n (no)
Active Channels
Number of active channels
status link 1 Page 1 of 4
LINK/PORT STATUS
Link Number: 1
Link Status: connected
Link Type: ethernet
Link Name: gert_clan1
Service Port Location: 01A0317
Service Port Data Extension: 70050
Service State: in-service/active
Node Name: gert_clan1
Source IP Address: 172.22.22.177
Subnet Mask: 255.255.0.0
Broadcast Address: 172.22.255.255
Physical Address: 00:04:0d:05:37:1d
Enabled? yes
Maintenance Busy? no
Active Channels: 2
To Next Page
Loading...
