Maintenance Commands
555-233-143
7-366 Issue 1 May 2002
Output
Separate columns identify each Packet Interface circuit pack slot. Service state is
displayed for both active and standby packet-interface circuit packs. A cabinet
number must be specified. If there are no IPSIs in the cabinet, this error message
is displayed: No IPSI in cabinet specified. Locate using list ipserver-interface.
The following display shows a typical result when
status packet-interface is
entered.
Field Descriptions
Location
The packet-interface cabinet, carrier and circuit pack position number.
Service
State
One of the following states is displayed: "in-service", "out-of-service" or
"uninstalled". The "standby" state is used in place of "in-service" for standby
packet-interface circuit packs.
Total Links
The total number of links.
Active
Links
The number of links that are in use.
Failed
Links
The number of links that failed to be established. These links are in a recovery
state and not active. The failures can arise from problems in the packet-interface,
EI or center stage hardware. The number of failed links is the number of total
links minus the number of active links.
status packet-interface 1
PACKET INTERFACE STATUS
Location: 01A
Service State: in-service
Total Links: 81
Active Links: 81
Failed Links: 0
Command:
To Next Page
Loading...
