Maintenance Commands
555-233-143
7-388 Issue 1 May 2002
Field Descriptions (Page 3)
IP Signaling:
Switch Port
The C-LAN board location serving the switch end of the IP signaling link.
The port number is always 17 for the “ethernet” port of the C-LAN. This field
will be blank for an unregistered H.323 station.
IP Signaling:
Switch-end IP
Addr and Port
Switch-end Q.931 (H.323 station) or CCMS (IP SoftPhone) IP signaling
address and IP port. IP address is of the form xxx.xxx.xxx.xxx where xxx
have decimal values 0-255. IP Port has a decimal value 0-65535.
This
field will be blank for an unregistered H.323 station.
IP Signaling:
Set-end IP Addr
and Port
Set-end Q.931 IP signaling address and IP port. IP address is of the form
xxx.xxx.xxx.xxx where xxx have decimal values 0-255. IP port is a decimal
value 0-65535. This field will be blank for an unregistered H.323 station.
H.245: Switch
Port
The C-LAN port serving the H.245 signaling link. The port number is always
17 for the “ethernet” port. This field is blank for an unregistered H.323
station, a VPhone, or when H.245 tunneling in Q.931 is used.
H.245:
Switch-end IP
Addr and Port
Switch-end H.245 IP signaling address and TCP/IP port. IP address is of
the form xxx.xxx.xxx.xxx where xxx is 0-255. IP Port is 0-65535. This field
is blank for IP SoftPhone endpoints and those endpoints using Q.931
tunneling of H.245. This field will be blank for an unregistered or inactive
H.323 station.
H.245:
Set-end IP Addr
and Port
Set-end H.245 IP signaling address and IP Port. IP Address is of the form
xxx.xxx.xxx.xxx where xxx have decimal values 0-255. IP Port is 0-65535.
This field is blank for IP SoftPhone endpoints and those endpoints using
Q.931 tunneling of H.245. This field will be blank for an unregistered or
inactive H.323 station.
Node Name (for
Call Control)
Label administered for an IP address.
Network Region
(for Call
Control)
A number given to a set of IP addresses to indicate they have a common
set of characteristics.
xxxxxxx Audio
The type of audio active for the station. The xxxxxxxx preceding Audio can
have one of these values: G.711-MU, G711-A, G.729A, G.723.1-6.3,
G.723.1-5.3, PCM, 711-MU, 711-A, 729, 729A, 729B, 729-AB, or
723.1-5.3/6.3. If the station is a telecommuter IP SoftPhone configuration
with call-back audio, xxxxxxxx will be set to PCM. If no audio path is
present, the xxxxxxxx field will be blank.
Audio: Port
The physical port used to provide audio path for the endpoint. The port
represents a MedPro port for H.323 stations, or for stations using a H.323
endpoint for audio. The field will be blank for stations with no established
audio path, or for telecommuter stations. In particular, an idle IP SoftPhone
or H.323 station with an as-needed service link will show no audio port.
Audio:
Other-end IP
Addr and Port
Other-end IP audio address and IP port. IP address is of the form
xxx.xxx.xxx.xxx where xxx have decimal values 0-255. Port is a decimal
value 0-65535. This field will be blank for an idle station with no audio link,
or for a telecommuter IP SoftPhone with circuit-switched audio link.
To Next Page
Loading...
