traceroute
Issue 1 May 2002
7-465555-233-143
Output
The following shows an example output for the C-LAN traceroute command. For
Medpro boards, the
clan-port (1-17) qualifier does not appear.
Field Descriptions
clan-port
This C-LAN entry identifies the port on the C-LAN board from
which the traceroute command is issued. This field appears
only if the board is a C-LAN board.
Hop
The node number (in sequence). The first node (0) is the
address from which the traceroute command is issued.
Time (ms)
Time from the board to each intermediate destination in
milliseconds. If an error occurs at a node, the entry is repeated
with an error code immediately following the time. Error codes
and their meanings are:
■ ! Unable to reach port
■ !N Unable to reach network
■ !H Unable to reach host
■ !P Failure between endpoints
■ !F Need fragmentation of data packet
■ !S Source return failure
■ !X Packet blocked by filter
IP Address
The 32-bit network address.
traceroute ip-address 135.9.1.22 board 1C14 clan-port (1-17)
TRACE ROUTE RESULTS
Hop Time(ms) IP Address
0 from address 135.9.1.22
1 03,10,05 134.9.14.23
2 11,20,03 134.9.5.103
3 22,01,25 106.245.27.205
4 22,01,25 !N 106.245.27.205
traceroute ip-address 135.9.1.22 board 1C14 clan-port (1-17)
TRACE ROUTE RESULTS
Hop Time(ms) IP Address
0 from address 135.9.1.22
1 03,10,05 134.9.14.23
2 11,20,03 134.9.5.103
3 22,01,25 106.245.27.205
4 22,01,25 !N 106.245.27.205
To Next Page
Loading...
