Maintenance-Object Repair Procedures
555-233-143
8-62 Issue 1 May 2002
PASS The port is able to provide an analog transmission path to the station
equipment. User-reported troubles on this port should be investigated by
using other port tests, by examining station wiring, or by examining the
station.
0NO
BOARD
The test could not relate the internal ID to the port (no board). This could be
due to incorrect translations, no board is inserted, an incorrect board is
inserted, or an insane board is inserted.
1. Verify that the board’s translations are correct. Use the list config
command, and resolve any problems.
2. If the board was found to be correctly inserted in step 1, issue the
busyout board command.
3. Issue the reset board command.
4. Issue the release busy board command.
5. Issue the test board long command.
This should re-establish the linkage between the internal ID and the port.
If not, verify that a valid board is inserted.
Table 8-25. Test #161 Loop-Around Test — Continued
Error
Code
Te s t
Result Description / Recommendation
Continued on next page
To Next Page
Loading...
