ANL-LINE, ANL-NE-L (8-Port Analog Line)
Issue 1 May 2002
8-91555-233-143
2000 ABORT Response to the test request was not received within the allowable time period.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
1 FAIL This does not indicate a hardware problem. The switchhook audit failed, and
the other updates were not performed because of this failure. This condition
may occur when the audit is performed at the same time that the terminal
equipment goes off-hook. Use the status station command to determine
when the port is available for testing.
1. When the port becomes available for testing, retry the command at
1-minute intervals up to 5 times.
5 FAIL This does not indicate a hardware problem but may indicate an internal
software error. The message waiting lamp update failed. The translation and
ringer updates were not performed because of this failure.
7 FAIL The translation update failed. The ringer update was not performed because of
this failure. This does not indicate a hardware problem but may be an internal
software error.
8 FAIL This does not indicate a hardware problem but may be an internal software
error. The ringer update failed.
1. Retry the command at 1-minute intervals up to 5 times.
PASS The software and the port processor have the same status. User-reported
troubles on this port should be investigated by using other port tests, by
examining station wiring, by examining the station, and by ensuring that the
terminal is correctly translated as off-premises or on-premises.
NOTE:
This test always passes for circuit packs TN712 prior to vintage 14 and
TN742 prior to vintage 6.
Table 8-36. Test #36 Station Status and Translation
Audits and Updates Test — Continued
Error
Code
Tes t
Result Description / Recommendation
Continued on next page
To Next Page
Loading...
