Avaya S8700 - Page 827

AN-LN-PT (Analog Line Port)
Issue 1 May 2002
8-105555-233-143
1004 ABORT A valid call seized the port during the test and aborted the test.
1. Use the display port UUCSSpp command to determine the station
extension.
2. Use the status station extension command to determine the service
state of the port.
3. If the port is active, wait until it is idle before testing. Retry the command at
1-minute intervals up to 5 times.
4. If the test continues to abort, escalate the problem.
1005 ABORT This test was aborted due to a configuration problem. The test is not applicable
for this type of analog port. This error can be ignored.
1018 ABORT Administration has disabled the test. The default for the
Test? field on the
station form is y. Determine why this field has been set to n on this station (this
may be due to the ringing application Test #48, which can be disturbing to
customer or terminal equipment).
1. To enable the test for a particular station being tested, enter change
station extension.
2. Change the Test? field on the station form to y.
2000 ABORT Response to the test request was not received within the allowable time period.
2100 ABORT System resources required to run test are not available. This could be due to a
failure to seize the port.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to abort, escalate the problem.
Any FAIL This test can fail due to either on- or off-board problems. Off-board problems
include TDM-BUS faults, EXP-PN and EXP-INTF faults, and faults associated
with the Tone Detectors/Tone Generators. Clear every off-board problem
before replacing the board.
1. A TDM-BUS problem is usually the result of a faulty board connection to
the backplane, or bent pins on the backplane. Resolve any TDM-BUS
errors in the error log.
2. Resolve any EXP-PN and EXP-INTF errors in the error log.
3. Resolve any TONE-BD and/or TONE-PT errors in the error log.
4. Test the board when the faults from steps 1, 2, and 3 are cleared. Replace
the board only if the test fails.
PASS The port is correctly using its allocated time slots. Investigate user-reported
troubles on this port by running other port tests, by examining station wiring, or
by inspecting the station.
Table 8-40. Test #6 NPE Crosstalk Test — Continued
Error
Code
Tes t
Result Description / Recommendation
Continued on next page