ANN-BD (Announcement Circuit Pack)
Issue 1 May 2002
8-133555-233-143
2007 ABORT The Announcement circuit pack thinks that Port 1 or Port 9 is busy.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to abort, follow the Announcement port maintenance
procedures for Ports 1 and 9.
2100 ABORT Could not allocate the necessary system resources to run this test.
ABORT Internal system error. Retry the command at 1-minute intervals up to 5 times.
1–3 FAIL Test failed. The error code indicates at which speech compression rate the test
actually failed (1 being the first rate tested, 3 being the last).
1. Reset the circuit pack using the reset board UUCSS command and then
run this test again. If the test continues to fail, replace the circuit pack.
2. If there are recurring alarms on this circuit pack caused by this test failing,
replace the circuit pack even if step 1 works.
!
CAUTION:
Replacing the circuit pack causes a loss of integrated announcements.
See ‘‘Essential Service Information’’ on page 8-120 of AN-LN-PT MO.
PASS The record channel on the announcement circuit pack is functioning properly.
User-reported troubles on this circuit pack should be investigated using other
circuit pack and port tests. Refer to “ANN-PT” for a description of the port tests.
Table 8-49. Test #210 140AY Loop-Around Test — Continued
Error
Code
Tes t
Result Description / Recommendation
Continued on next page
To Next Page
Loading...
