Avaya S8700 - Page 857

ANN-BD (Announcement Circuit Pack)
Issue 1 May 2002
8-135555-233-143
Table 8-51. Test #212 Clock Match Inquiry Test
Error
Code
Tes t
Result Description / Recommendation
2000 ABORT Response to the test was not received within the allowable time period. If Error
Type 1538 is present in the Error Log, follow the procedure for that error.
2100 ABORT Could not allocate the necessary system resources to run this test.
ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
FAIL The ANN-BD may be defective, or the active Tone-Clock circuit in the same
EPN may be bad. Announcements recorded or played back while the clock
circuitry is not functioning properly sound distorted.
1. Enter reset board UUCSS to reset the Announcement circuit pack, and
run this test again. If the test continues to fail, proceed to step 2 or 3,
whichever applies.
2. If this EPN has duplicated Tone-Clocks:
a. Enter status port-network 1 to determine the EPN’s active TONE-BD.
b. Enter set tone-clock UUC to make the standby Tone-Clock or IPSI
circuit pack active.
c. Rerun the test. If the test passes, replace the now standby Tone-Clock
or IPSI circuit pack. If not, replace the ANN-BD circuit pack.
!
CAUTION:
Replacing the announcement circuit pack results in loss of integrated
announcements. See ‘‘Essential Service Information’’. See ‘‘TONE-BD
(Tone-Clock Circuit)’’ for Tone-Clock replacement instructions.
3. If the EPN has a single Tone-Clock, replace the ANN-BD, and rerun the
test. If the test continues to fail, replace the Tone-Clock circuit pack
located in the same EPN as the ANN-BD.
!
CAUTION:
Replacing an unduplicated EPN Tone-Clock will cause an EPN reset with
service outage to that EPN. See ‘‘Replacing the IPSI or Tone-Clock
Circuit Pack’’ on page 8-1666. Replacing the circuit pack causes a loss
of integrated announcements. See ‘‘Essential Service Information’’ on
page 8-120 of AN-LN-PT MO.
4. If failures of this test continue to raise alarms, replace the circuit pack even
if the previous steps were successful.
PASS Announcement playbacks must have clear sound quality. Investigate
user-reported troubles on this circuit pack using the other circuit pack and port
tests. Refer to “ANN-PT” for descriptions of the port tests.
Continued on next page