ANN-PT (Announcement Port)
Issue 1 May 2002
8-141555-233-143
1 to
254
FAIL Test failed. The error code indicates the number of byte count errors found by
the Tone Detector.
1. Reset the circuit pack via the reset board UUCSS command and then run
this test again. If the test continues to fail, replace the circuit pack.
2. If there are recurring alarms on this port caused by this test failing, replace
the circuit pack even if step 1 works.
!
CAUTION:
Replacing the circuit pack causes a loss of integrated announcements.
Refer to ‘‘Essential Service Information’’ on page 8-120 of the AN-LN-PT
MO.
255 FAIL Test failed. The announcement port and the Tone Detector never
synchronized. Check for active GPTD-PT errors, and see ‘‘GPTD-PT
(General-Purpose Tone Detector Port)’’ to diagnose them first.
1. If there are no active GPTD-PT errors, reset the circuit pack using the
reset board UUCSS command and then run this test again. If the test
continues to fail, replace the circuit pack.
2. If there are recurring alarms on this port caused by this test failing, replace
the circuit pack even if step 1 works. See Caution, above.
PASS This port can cleanly play announcements. User-reported troubles on this pack
should be investigated using other port and circuit pack tests. Refer to
‘‘AN-LN-PT (Analog Line Port)’’ for a description of the circuit pack tests.
Table 8-54. Test #206 PSMA (Playback Speech Memory Array) Test — Continued
Error
Code
Tes t
Result Description / Recommendation
Continued on next page
To Next Page
Loading...
