Avaya S8700 - Page 876

Maintenance-Object Repair Procedures
555-233-143
8-154 Issue 1 May 2002
Table 8-58. Test #626 Signaling Link Status Test
Error
Code
Tes t
Result Description / Recommendation
1139 ABORT The EPN’s packet bus is out-of-service.
1. Follow the repair procedures for the packet bus.
2. After completing step 1, execute the test port long UUCSSpp command
and review the results of the BRI Port Local LAN Looparound test (#618) to
verify the repair.
1141 ABORT The PKT-CTRL is out-of-service.
1. Refer to PKT-CTRL maintenance documentation.
1187 ABORT The circuit pack, port, or station may have been busied out.
1. Look in the Error Log for Error Type 18 (busied out) for ASAI-BD, ASAI-PT,
or ASAI-EPT.
2. If this Error Type is present for ASAI-EPT only, then use the release
station command and run the test again.
3. If this Error Type is present for ASAI-PT and ASAI-EPT, then use the
release port command and run the test again.
4. If this Error Type is present for ASAI-BD, ASAI-PT, and ASAI-EPT, then
use the release board command and run the test again.
2012 ABORT Internal system error
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
1113 FAIL The signaling link is not “bound” to the adjunct. For ASAI adjuncts this error
indicates that the link is disconnected at Layer 2. Since the signaling link
associated with the endpoint has been identified by administration, the link is
only “unbound” from the endpoint when it is disconnected.
1. Execute the status bri-port UUCSSpp command and see ‘‘BRI-PORT
(ISDN-BRI Port), ABRI-PORT (ASAI ISDN-BRI Port)’’.
PASS The signaling link is connected at Layer 2 and “bound” to the ASAI adjunct.
Continued on next page