Avaya S8700 - Page 884

Maintenance-Object Repair Procedures
555-233-143
8-162 Issue 1 May 2002
3 FAIL Received a status of Level 1 Deactivated; the port is out of service.
1. Issue the status bri-port UUCSSpp command to verify that the service
state of the port is out-of-service. If the port is not out of service, escalate
the problem, or else proceed to step 2.
2. If the port has been placed out-of-service using the busyout port
UUCSSpp command, try releasing the port by executing the release port
UUCSSpp command. Then issue the test port long UUCSSpp
command, and review the results of Level 1 Status Inquiry test. If this test
is still failing, proceed to step 3.
3. After executing the test port long UUCSSpp command, review the results
of every test. Follow the repair procedures for any tests that fail. Verify
repair of the problem by executing the test port UUCSSpp command and
by determining that the Level 1 Status test passes.
4. If the test continues to fail for this reason, escalate the problem.
PASS This test indicates that Level 1 is activated, or that software has taken the port
out of service.
Table 8-62. Test #621 Level 1 Status Inquiry — Continued
Error
Code
Tes t
Result Description / Recommendation
Continued on next page