Avaya S8700 - Page 934

Maintenance-Object Repair Procedures
555-233-143
8-212 Issue 1 May 2002
If the circuit pack is a standby ATM-EI (amber LED off), this test queries the ATM
PNC Expansion Interface circuit pack for information about its type and vintage.
Table 8-87. Expansion Interface Control Channel Test #316
Error
Code
Tes t
Result Description / Recommendation
2000 ABORT Response to the test request was not received within the allowable time period.
2100 ABORT Could not allocate the necessary system resources to run this test.
2500 ABORT Internal system error
1. Retry the command at 1-minute intervals up to 3 times.
FAIL The ATM-EI circuit pack responded incorrectly or if it is the EPN active ATM-EI
circuit pack, it could not talk to EPN circuit packs.
1. If the active ATM-EI circuit pack in the EPN is failing and duplicated PNC is
enabled, attempt to switch to the standby PNC using the reset PNC
interchange command.
2. Repeat the short test sequence.
3. If test continues to fail, reset the ATM-EI circuit pack with the reset board
UUCSS command.
4. If the ATM-EI circuit pack in the EPN is failing, enter display errors and
display alarms, and resolve any TDM-CLK, TONE-BD, or SYNC
alarms/errors.
5. Repeat the short test sequence.
6. If test continues to fail, replace the circuit pack or transceiver.
PASS The ATM-EI circuit pack did respond correctly to test. Communication from
software to the ATM-EI circuit pack is functioning.
1. Refer to other ATM-EI circuit pack tests if the link is not functioning
correctly.
0NO
BOARD
No board was detected by the test.
1. Resolve any wrong board (Error 125) or no board (Error 131) issues.
2. Check that the board is properly translated and inserted. If so, check for
hyperactivity (Error 1538). If hyperactive, use the reset board UUCSS
command.
3. Run the test again. If it fails, the NCE chip on board could be bad.
Replace the board and retest.
Continued on next page