Avaya S8700 - Page 950

Maintenance-Object Repair Procedures
555-233-143
8-228 Issue 1 May 2002
1962 ABORT Every DSPs is busy (an unlikely event).
1. Retry the command at 1-minute intervals up to 3 times.
2000 ABORT Response to the test was not received within the allowable time period for
some of the DSPs.
1. If the board is in standby, reset the board and run the test again.
2. Look into the Error Log for Error Type 1218 (bad DSP). If Error Type 1218
is not logged against this board, run the DSP test again and see if the error
persists.
2100 ABORT Could not allocate the necessary system resources to run this test.
2302 ABORT Inconsistent uplink message from the ATM-EI board (an unlikely event).
1. Retry the command at 1-minute intervals up to 3 times.
2500 ABORT Internal system error
2752 ABORT The circuit pack in this location is not a TN230X.
XYZ FAIL A device on the circuit pack is failing. There is at least one bad DSP on the
board. Values are as follows:
■ The X value indicates the number of talker DSPs
■ Y indicates the number of listener DSPs
■ Z indicates the number of Echo Canceler DSPs that have failed the test.
1. Run the tests for the active Tone-Clock on the EPN that contains the
indicted ATM-EI circuit pack to verify that dial-tone is supplied.
2. If the Tone-Clock is healthy, repeat the short test on the ATM-EI board.
3. If this test continues to fail, replace the ATM-EI circuit pack.
XYZ PASS The test passed for some or all DSPs depending on XYZ values. XYZ
indicates the number of talker, listener and echo-canceler DSPs for which the
test passed, respectively. In the DSPs that passed the test, the test tone was
correctly detected by the DSP Listener and by tone-detector for the DSP
Talkers on both buses, and the Echo Canceler DSPs are working properly.
0NO
BOARD
No board was detected by the test.
1. Check the Error Log for wrong board (Error Type 125) or no board (Error
Type 131). Resolve either of these issues, if applicable.
2. Check that the board is properly translated and inserted. If so, check for
hyperactivity (Error Type 1538). If hyperactive, use the reset board
UUCSS command.
3. Run the test again. If it fails, the circuit pack could be bad. Replace the
circuit pack and retest.
Table 8-95. ATM Board DSP Test (#1293) — Continued
Error
Code
Tes t
Result Description / Recommendation
Continued on next page