ATM-SGRP (ATM Signaling Group)
Issue 1 May 2002
8-263555-233-143
Table 8-110. Test #1291 Remote Layer 3 Query
Error
Code
Tes t
Result Description / Recommendation
1006 ABORT There are no associated B channels in an ISDN “in-service” or “maintenance”
service state. This is a NORMAL ABORT.
1. Administer or release an ISDN trunk or PRI endpoint before retrying the
test. For an ATM trunk, use the status trunk grp#/mbr# command to
verify the ISDN trunk state.
2. Retry this test when at least one B channel is in the “in-service” or
“maintenance” states.
1113 ABORT The signaling channel is down. Therefore, no messages can be sent to the
far-end switch or terminal adapter.
1. Examine the results of Test #636, and follow recommendations provided
there.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
2500,
none
ABORT Internal system error or administration problem
1. Determine whether any B channels are administered.
2. If there are none, then this is a normal ABORT, since this test cannot run
unless at least one B channel is administered.
3. If at least one B channel is administered, there is an internal system error.
Retry the command at 1-minute intervals up to 5 times.
FAIL Internal system error
1. See description of ABORT with Error Code 2500.
PASS A message was sent to the far-end switch or terminal adapter. The ISDN PRI
specification allows up to 2 minutes for a reply.
1. Check the Error Log for ATM-SGRP errors of type 2305 for evidence of a
Remote Layer 3 Query failure.
2. If no new errors were logged since this test was run, then this switch and
the far-end switch can exchange call control messages.
3. If there is still a problem with a particular ATM trunk, busyout the trunk and
run the long test sequence, paying particular attention to the results of Test
#258 (ISDN test call).
Continued on next page
To Next Page
Loading...
