Configuration
Parameter manual b maXX BM3000
Document no.: 5.12001.07 Baumüller Nürnberg GmbH
198
of 820
4.4
Not generally all warnings were supported (see Z137.38– Warning mask).
The controller responds to a set warning with a corresponding error (error numbers 417
to 421). These can be always acknowledged.
137.42
137.43
Parameter of OEM 1, 2
Parameter of OEM 3, 4
These two parameters are only valid for EnDat
®
encoder.
The available OEM memories are displayed.
The controller uses these areas for the Baumueller motor type plate.
Bit Description
0 1: Collision of frequency
1 1: Excess temperature
2 1: Lighting controller reserve reached
3 1: Battery load to small
4 1: "Reference point crossed" will be supported
Residual Reserved
To Next Page
Loading...