Set Value Generators
Parameter manual b maXX BM3000
Document no.: 5.12001.07 Baumüller Nürnberg GmbH
436
of 820
4.6
159.10 Position virtual master axis
Specifies the position of the virtual master in the cam. It must be considered, that the max-
imum position of the virtual master axis is (supporting points - 1) * 256, because interpo-
lation is executed between the supporting points with 256. If the virtual master axis is
exactly on position 512, then the virtual master axis is positioned exactly on the 3
rd
sup-
porting point. If the virtual master axis is on position 105, then the virtual axis is positioned
between the 1
st
and the 2
nd
supporting point.
159.11 Input parameter
Input parameters for the parameter-controlled processing.
This parameter is combined with the reference value and amounts to the active table in-
dex. If the parameter is an integer data type, then additionally the shift factor is combined,
in order to amount to the active table index.
159.14 Basic value index calculation
At parameter-controlled processing the base value is subtracted from the input parame-
ter.
159.15 Shift factor index calculation
After the base value was subtracted from the input parameter, the resulting value is shift-
ed to the right by the shift factor, if the input parameters are integer data types.
159.16 Output parameter
The cam generator writes on this output parameter. All cyclic writable parameters can be
used as output parameters.
To Next Page
Loading...
Need help?
General