EasyManuals Logo

Baumuller b maXX BM3000 User Manual

Baumuller b maXX BM3000
822 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #766 background imageLoading...
Page #766 background image
Error descriptions
Parameter manual b maXX BM3000
Document no.: 5.12001.07 Baumüller Nürnberg GmbH
766
of 820
5.5
1815 No section exists for motor type plate in
the encoder memory
No section for a motor type plate exists in the encoder OEM mem-
ory.
Pulse block
1816 No section exists for notch position off-
set in the encoder memory
No section exists for notch position offset in the encoder OEM mem-
ory
Pulse block
1817 No section exists for M0 data in the
encoder memory
No section exists for M0 data in the encoder OEM memory Pulse block
1818 No section exists for operating data in
the encoder memory
No section exists for operating data in the encoder OEM memory Pulse block
1901 Connection did not exist, client was not
logged in.
No response
1902 GdpProtocol version not supported. No response
1903 Maximum number of users reached. No response
1904 Report ID not known. No GDP report No response
1905 CRC32 checksum does not match the
calculated checksum.
No response
1906 Telegram header size not plausible. No response
1907 Job length not plausible. No response
1908 Fragment length not plausible. No response
1909 Command not yet implemented. No response
1910 User is already logged in No response
1911 User is not logged in No response
1913 Too many parameters have been
requested
No response
1914 The Job ID is wrong in a sequence of
partial telegrams
No response
1915 Wrong count value for Parameter
Read-Write
No response
1917 OrderSpec not supported No response
1918 Buffer size of small block length not
plausible
No response
1919 Block length smaller than minimum
required size
No response
1920 Too many simultaneously active com-
mand
No response
1921 Command unknown No response
1922 Wrong list type No response
1923 Wrong parameter list ID No response
1924 Wrong parameter number for parame-
ter list
Wrong parameter number for parameter list No response
1925 Parameter does not exist No response
1926 List does not exist No response
1927 Wrong real time mode No response
1928 Value for Alive Timeout may not be 0 No response
1930 Index range wrong (Start-Index End-
Index or Max-DIM
No response
Error
num-
ber
Brief error text Error description Default set-
ting for
Error
Response

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Baumuller b maXX BM3000 and is the answer not in the manual?

Baumuller b maXX BM3000 Specifications

General IconGeneral
BrandBaumuller
Modelb maXX BM3000
CategoryMeasuring Instruments
LanguageEnglish