4-13
Confidential
(4) Assemble the Fuser cover R to the Fuser unit with the Taptite bind B M3x12 screw.
Fig. 4-17
(5) Assemble the Fuser cover L to the Fuser unit with the Taptite bind B M3x12 screw.
Fig. 4-18
Note:
Do not pinch the harness from the low-voltage power supply PCB ASSY to the Fuser
unit.
Note:
Mount the Fuser cover L as holding down the harness of the thermistor to the Side
frame L side. (If the harness is protruded, it hooks up the eject front actuator.)
Taptite bind B M3x12
Fuser unit
Fuser cover R
<Back side>
Fuser unit
Fuser cover L
Taptite bind B M3x12
<Back side>
Side frame L
To Next Page
Loading...
