Cedex HiRes - Specifying Default Measurement Parameters; Specifying Other Default Parameters; Specifying the Workarea for the Analysis Data

74
Cedex HiRes Analyzer Operator’s Guide
C
C
9.4.2. Specifying Default Measurement Parameters
The logged-in user can determine the preferred default values for certain measurement parameters (Cell Type,
dilution, etc.). The default parameter settings are only valid for this user.
Follow the instructions below to change the default values for certain measurement parameters:
1
Select User Preferences in the Master Data menu of the Cedex Control Center. The User Preferences
dialog box opens.
2
Select the Measurement tab in the User Preferences dialog box.
3
Manually type in the appropriate default measurement parameters in the Value column. The defaults for the
following parameters can be determined:
c
CellType
c DefaultCombinedNumber (for the Measurement Statistics Histogram)
c MeasurementPrecision
c ReactorID
c SampleInitialDilution
c SampleVolume
c Workarea
4
Put a checkmark in the checkbox of the Save Last column if the last value used for a measurement should
be used as the default for the next measurement.
5
Click on SAVE to confirm.
6
Close the dialog box. The new default parameters will apply to new measurements.
■
9.4.3. Specifying Other Default Parameters
Other default parameters can be specified for the Measurement List dialog box and the CTC Views dialog box.
Select the following tabs to create or alter default parameters:
c
Measurement Default Filter: Create or alter default parameters for filter settings in the Measurement List
dialog box.
c CTC Views Default Filter: Create or alter default parameters for the filter settings in the CTC Views
dialog box.
9.4.4. Specifying the Workarea for the Analysis Data
The analysis results are stored in the workarea that is selected in the Measurement dialog box before a
measurement is run. If analysis results from a specific workarea are to be viewed, the appropriate workarea
needs to be chosen from the drop-down list in the Measurement List dialog box.
The user can only choose a workarea from the list of workareas to which she/he has been assigned. Only the
Administrator has the right to assign workareas (see “Administration of User Accounts”).
General Functions of the System
User Preferences