28
Cedex HiRes Analyzer Operator’s Guide
B
B
4 Starting the Cedex HiRes Analyzer
The hardware components of the Cedex HiRes Analyzer must be turned on before the analysis Software can be
started, otherwise the Software will not be properly initialized.
After the initial installation, turn on the individual devices in the order given below:
1
Turn on the Cedex HiRes Analyzer.
2
Turn on the monitor and the Control Unit. The first time the Control Unit is started, a registration dialog box
for access at the operating system level may appear. Follow the instructions to register with Windows, if
required.
■
To ensure that the Cedex HiRes Analyzer is fully operational, an Intensive Clean must be carried out once
per week even if the system is not being used for measurements. Therefore, a Reagent Kit must be installed
directly after the installation of the Cedex HiRes Analyzer to allow for the required cleaning routines (see
Section D “Installing or Changing the Reagent Kit”).
Step-by-step instructions for preparing the Cedex HiRes Analyzer for measurements, performing
measurements, and shutting down the Cedex HiRes Analyzer, are located in the Cedex HiRes Analyzer User
Training Guide.
Starting the Cedex HiRes Analyzer
To Next Page
Loading...