26
Cedex HiRes Analyzer Software Version 2.4 - Training Guide
B
B
Adding Measurements to the List While Measurements are Running
Sample rows in which data has not yet been entered can be filled out at any time while the Multi Run is running.
In addition, sample rows containing finished measurements (status: done) can be cleared and prepared for a
new measurement by double-clicking in the Status field of the row with the finished measurement. Sample data
for a measurement cannot be modified after that measurement has begun.
Modifying Data Entry, Changing Samples
Information about the operation and process parameters for samples that have not yet been analyzed can be
modified during the run.
1
Double-click on the Status field of the measurement to be modified.
The status field indicates that the sample is in edit mode.
2
Make desired changes to the measurement.
3
Double-click on the Status field to reactivate the measurement (status: scheduled).
n
Wait until the Multi Sample Tray has stopped moving before changing the samples.
7.4 Interrupting a Multi Run
The START button switches to a STOP button after a Multi Run has started.
1
Click on the STOP button to pause or stop the Multi Run. If a sample is being measured when the
STOP button is pressed, that measurement is completed.
All scheduled measurements (status: scheduled) switch to active status, and the STOP button reverts to
START.
2
Click on the START button again to continue analysis of scheduled measurements.
n
7.5 Results
After a Multi Run has finished, the results for all measurements are stored and displayed in the Measurement List
dialog box. See Chapter 8, The Measurement List. In addition, some results for the measurements are displayed
in the Analyzed Measurements field at the bottom of the Multi Run dialog box.
Setting up Multiple Measurements Using the Multi Run Dialog Box
Interrupting a Multi Run
To Next Page
Loading...