2 / 2
08385793001
4
102017
For use in quality control/manufacturing process only.
CEDEX is a trademark of Roche.
All other product names and trademarks are the property of their respective owners.
Working with the Multi Sampler — (October 2017)
Modifying Data Entry, Changing Samples
Information about the operation and process parameters for samples that have not yet been
analyzed can be modified during the run as follows:
1
Double-click on the Status field of the measurement to be modified. The status field will
indicate that the sample is in edit mode.
2
Make desired changes to the measurement.
3
Double-click on the Status field to re-activate the measurement
(status: scheduled).
■
Adding Measurements to the List While Measurements are Running
Sample rows in which data has not yet been entered can be filled out at any time while the
Multi Run is running. In addition, sample rows containing finished measurements (status:
done) can be cleared and prepared for a new measurement by double-clicking in the Status
field of the row with the finished measurement. Sample data for a measurement cannot be
modified after that measurement has begun.
Viewing Results Via the Multi Run Result List
At the bottom of the Multi Run dialog box, the Analyzed Measurements field displays the
list of results for measurements previously carried out. Measurements are listed in order of
process time, from the newest measurements at the top of the list to the oldest measurements at
the bottom. All measurements carried out using the Multi Run dialog box will be displayed in
this field unless the Clear Resultlist button has been pressed, which will clear all measurement
results from the list.
In addition, measurements displayed in this field can be restricted to only the measurements
carried out by the user logged into the system (mine), measurements that have not yet been
printed out (unprinted), and/or measurements carried out on that particular day (today).
Other results, such as Average Diameter, can be added for display in the result list via the
User Preferences (see “Adjusting Result Display in the Measurement List and Multi Run dialog
boxes” in the Cedex HiRes Analyzer Operator’s Guide). Double-click on a measurement to
view all results. If the result list has been cleared, previously carried out measurements can
still be viewed, printed out, and exported via the Measurement List dialog box (see “Using the
Measurement List” in the Cedex HiRes Analyzer Operator’s Guide).
Cedex HiRes Software 2.4 Quick Guide
Roche Diagnostics GmbH
Sandhofer Straße 116
68305 Mannheim
Germany
© 2017 Roche Diagnostics.
All rights reserved.
To Next Page
Loading...